How to sink a blind deep?

[biggun]

U want to angle your 2X6 to where when u drive them the ends will be lower than where U want to bolt them...

Once u have your blind at the height U want lay your boards on the 6" flat. drive your boards. When U get to the end pull up on the board.. To put board under tension...

That when U bolt it to blind. Driving your boards in an X pattern...

If U contact me I can tell U how.. Anchors are Only needed on your sides.. Not front or back.

BTW.. 24" top opening is a little small.. I'd go with about 26-28' top opening.. IMO 24'' doesn't allow u to turn around easily..