Mako repower success

[shellman]

You can learn a lot on engine installs and electronic installs. I think it looks much neater for In dash electronics . Just use template and put down painters tape before cutting hole and make sure backside is clear before cutting.Use all heat shrink connectors for wiring.

[Crawl79]

Originally Posted by shellman

You can learn a lot on engine installs and electronic installs. I think it looks much neater for In dash electronics . Just use template and put down painters tape before cutting hole and make sure backside is clear before cutting.Use all heat shrink connectors for wiring.

Good advice, Gasper is an electrical engineer so he re-wired everything. It is a much neater electronics install than the original.