Is my outboard mounted too low?

[booyagasha]

dang....just checked out the boat and my bilge aint working....flip the switch nothing...checked fuses...everything ok...

what should i look for

[Shawn Braquet]

Originally Posted by booyagasha

dang....just checked out the boat and my bilge aint working....flip the switch nothing...checked fuses...everything ok...

what should i look for

if you have a volt meter, check for voltage at the pump, if you gots you some volts time for a new pump

[Gerald]

Originally Posted by booyagasha

dang....just checked out the boat and my bilge aint working....flip the switch nothing...checked fuses...everything ok...

what should i look for

Did you use a volt meter and check to see if you were getting 12 volts on each side of the fuses? Check voltage until you find where the problem is located.

Shawn.....we were typing at the same time.

[alphaman]

get a test light see if you have fire at the bilge (if u do motor may be bad) if you dont check the ground wire, then try again c if it works. ground wire needs to be grounded good.

[booyagasha]

Gonna check it once fathers day calms down thanks for the input

[flounder_smacker]

did you figure out how to take that pin out?

[booyagasha]

Originally Posted by flounder_smacker

did you figure out how to take that pin out?

man, truthfully, between boiling crawfish, and trying to figure out what's wrong witht the bilge, i never even got to look at it. not too mention the scorcher today.ill have a look after class tomorrow.