We couldn't sand the top of the visor too much because it was just glued on at the bottom, so today we decided to glass the whole thing except the top three inches. So it's hard now, but we still haven't had a chance to clean it up yet. And then we got the floor over the gas tank put in. I was a bit worried about the floor, I didn't want water to sit in the middle so I gave the middle section a half inch of crown, but you can't really see it. I think it'll work out perfect.
And then I tried to get a good picture of the visor in the daylight, but there's a boat next to mine so it's hard to get a good side view! There is still a low spot on the left and a high spot on the left, but we'll get it quick when we get a chance.
12-23-2015, 10:18 PM
Threaded Mode