Thread: Changing go-devil bearing
View Single Post
  #1  
Old 12-17-2009, 10:06 PM
cordgrass's Avatar
cordgrass cordgrass is offline
Redfish
  
Join Date: May 2009
Location: Thibodaux but from Ville Platte
Posts: 143
Cash: 745
Default Changing go-devil bearing
i went run my go-devil today and while i was running the seal on the upper end of the shaft (near the motor) caught on fire. I removed the the shaft. Now how do i replace lower and upper seal? Is there anything i need to know on replacing these? The shaft had no scarring on it. any info would help thanks. bearings i meant seals.
Last edited by cordgrass; 12-17-2009 at 10:58 PM.
Reply With Quote