Well, not too many interesting pictures, we have a 4 man sanding crew running now full time, and then me and Harold are slowing finshing the rest of the building part.
We finished the hole on the right to be the ice chest, with 2 inch diviny cell all the way around, but then I decided it was too small so we went back in and made the hole on the left 2 inch diviny cell as well. So now we have a huge ice chest! This is a picture before it was faired, it's white now and actually pretty close to being ready to gelcoat. Today was very productive.
We changed up the plan here as well. The top part I'm going to put hinges on so it lifts up and then stays in place with a spring. And then we'll have double doors in the front:
Got the section of floor down behind the motor. I wasn't sure how to do this with the fighting chair, so I put 4 layers of 1708 on the top and bottom of the floor, and then we built a big aluminum washer for the bottom of the chair mount and then we will through bolt it. There is a hatch in the floor right in front of where the chair goes, but the pictures can't keep up with production
And on the above picture I don't know if you can make it out but there is a 1 inch crown in the back that came out very nice. The last section will go to 2 inches, but the live well will be in the middle so you don't walk on the more extreme crown.
And then this is the gunnel in the back. It's getting pretty fair. We actually made another pass after this picture was taken
And then here are some outside of the boat shots. We've have made a pair of passes after these photos as well.
We're getting closer. Going to take off the first, I might go out there to shoot some pictures, and then on the 2nd we're going to hit it hard some more!