Homeade water buffalo
 

Looking for ideas on how to roll some semi marsh. It's probably as hard as a second crop cut rice field. Trying to make a buffalo without breaking the bank. Any ideas would be appreciated


"Go ahead, share your opinion! I won't cry"

Minus the ruts


"Go ahead, share your opinion! I won't cry"

How big you gotta make it? We pull a piece of grading behind a fourwheeler


Sent from my iPhone using Tapatalk - now Free

Made one out of 8 inch pipe, 3 inch angle iron for teeth,frame out of square tubing. Bearings on each end but you can keep it simple with a steel dowel rod welded to the end cap and pipe that slips over it for bearing. Seen one like that and it works just fine

Thx


"Go ahead, share your opinion! I won't cry"

I'm sure I don't need to tell you this, but if your pulling behind a four wheeler make sure it's not too heavy and that your wheel is big enough. Ruined the transmission on my foreman 500 doing ours with a buffalo we borrowed.


Sent from my iPhone using Tapatalk

Oh lawd... Yea I hear ya. We will be doing it with an argo


"Go ahead, share your opinion! I won't cry"

If it's cat tails and the Argo is floating you ain't going no where


Sent from my iPhone using Tapatalk - now Free

It's a lil bit o cat tail but it's only 1' water


"Go ahead, share your opinion! I won't cry"

Then you should roll pretty good I believe.


Sent from my iPhone using Tapatalk

CAn't pick up a second hand one sitting in someone's yard covered in grass?

If you find one let me know. Never seen one just sitting in a yard. But I haven't seen everything


"Go ahead, share your opinion! I won't cry"

Jdm4x4 does it and has his own

Gizzle I have a classmate that may have one, I check with him for u

what is a water buffalo? searched and cant find anything

Basically a big drum with big, flat spikes/blades used to mash stubble in water

U can get a 4-6' piece of telephone pole.. Put big nails in it.. use some rope on both ends; U in business.